eLibrary >
BS 7629-1:2015+A1:2019 Electric cables. Specification for 300/500 V fire resistant, screened, fixed installation cables having low emission of smoke and corrosive gases when affected by fire - Multicore cables >
BS 7629-1:2015+A1:2019 Electric cables. Specification for 300/500 V fire resistant, screened, fixed installation cables having low emission of smoke and corrosive gases when affected by fire - Multicore cables, 2019
- Foreword
- 1 Scope
- 2 Normative references
- 3 Terms and definitions
- 4 Voltage designation and fire resistance categories [Go to Page]
- 5 Conductors and drain wire [Go to Page]
- 6 Insulation system [Go to Page]
- 7 Identification of cores [Go to Page]
- 8 Laying-up [Go to Page]
- 9 Screen
- 10 Sheath [Go to Page]
- 11 Cable marking and additional information [Go to Page]
- 12 Schedule of tests [Go to Page]
- 13 Test conditions [Go to Page]
- 14 Routine tests [Go to Page]
- 15 Sample tests [Go to Page]
- 16 Type tests [Go to Page]
- Annex A (informative) Guide to selection, installation and operation
- Annex B (normative) Method of test for continuity of tinned coatings of wires
- Annex C (normative) Method of test for voltage withstand
- Annex D (normative) Method of test for bending characteristics
- Annex E (normative) Method of test for resistance to impact [Go to Page]
- Annex F (normative) Method of test for shrinkage of sheath on cable during heat treatment
- Annex G (informative) Notes on type tests
- Bibliography [Go to Page]