eLibrary >
BS EN 12392:2025 Aluminium and aluminium alloys. Wrought products and cast products. Special requirements for products intended for the production of pressure equipment >
BS EN 12392:2025 Aluminium and aluminium alloys. Wrought products and cast products. Special requirements for products intended for the production of pressure equipment, 2025
- undefined
- European foreword
- 1 Scope
- 2 Normative references
- 3 Terms and definitions
- 4 Symbols
- Table 1 — Symbols and designations
- 5 Materials [Go to Page]
- 6 Technical conditions for inspection and delivery [Go to Page]
- 7 Mechanical properties [Go to Page]
- 8 Tolerances on dimensions and form [Go to Page]
- Table 2 — List of alloys – tempers – product forms – wrought products
- Table 3 — List of alloys – tempers – castings
- Table 4 — Applicable limitations for porthole products according to EN 754 series, EN 755 series and EN 12020 series (as specified in 6.1.2 and 6.3.5.2)
- Table 5 — Applicable limitations for porthole extruded products according to EN 13957:2008 and EN 13958:2008 (as specified in 6.1.2 and 6.3.5.2)
- Table 6 — Mechanical properties for unalloyed aluminium in tempers O, H111 or H112
- Table 7 — Flattening test – Specified H values
- Table 8 — Flaring test – Specified C values
- Table 9 — Mechanical properties at room temperature – forgings
- Annex A (informative) Materials and application ranges
- Table A.1 — Materials and application ranges – Wrought products
- Table A.2 — Materials and application ranges – cast products
- Annex B (informative) Tensile properties at low and high temperatures
- B.1 General
- B.2 Wrought products
- Table B.1 — Low and high temperature property values (unalloyed aluminium)
- Table B.2 — Low and high temperature property values (aluminium alloys)
- B.3 Cast products
- Table B.3 — Low and high temperature property values — Cast products – sand cast products
- Table B.4 — Low and high temperature property values — Cast products – permanent mould cast products
- Annex C (normative) Empirical conversion between values of A and A50
- Table C.1 — Numerical relationship between A and A50
- Annex D (informative) Significant technical changes between this document and its previous edition
- Annex ZA (informative) Relationship between this European Standard and the essential safety requirements of Directive 2014/68/EU aimed to be covered
- Table ZA.1 — Correspondence between this European Standard and the Annex I of the Directive 2014/68/EU (Pressure Equipment Directive)
- Bibliography [Go to Page]