eLibrary >
BS EN ISO 14910-2:2013 Plastics. Thermoplastic polyester/ester and polyether/ester elastomers for moulding and extrusion - Preparation of test specimens and determination of properties >
BS EN ISO 14910-2:2013 Plastics. Thermoplastic polyester/ester and polyether/ester elastomers for moulding and extrusion - Preparation of test specimens and determination of properties, 2016
- Figure fig_1
- Section sec_1
- Section sec_2
- Section sec_3
- Section sec_3.1
- Table tab_1
- Section sec_3.2
- Table tab_2
- Section sec_4
- Section sec_5
- Section sec_5.1
- Table tab_3
- Section sec_5.2
- Section sec_5.2.1
- Table tab_4
- Section sec_5.2.2
- Table tab_5
- Section sec_5.3
- Section sec_5.3.1
- Table tab_6
- Section sec_5.3.2
- Table tab_7
- Section sec_5.4
- Section sec_5.4.1
- Table tab_8
- Section sec_5.4.2
- Table tab_9
- Reference ref_1
- Foreword
- Introduction
- 1 Scope
- 2 Normative references
- 3 Preparation of test specimens
- 3.1 Treatment of the material before moulding
- 3.2 Injection moulding
- 4 Conditioning of test specimens
- 5 Determination of properties
- 5.1 General
- 5.2 Shore D hardness ≤ 25
- 5.3 25 < Shore D hardness ≤ 65
- 5.4 Shore D hardness > 65
- Bibliography
- 30196252-VOR.pdf [Go to Page]