eLibrary >
ISO 16230-1:2015 Agricultural machinery and tractors - Safety of higher voltage electrical and electronic components and systems - Part 1: General requirements >
ISO 16230-1:2015 Agricultural machinery and tractors - Safety of higher voltage electrical and electronic components and systems - Part 1: General requirements, 2015
- Foreword
- Introduction
- 1 Scope
- 2 Normative references
- 3 Terms and definitions
- 4 General requirements
- 4.1 Standards
- 4.2 Component selection
- 5 Protection of persons against electric shock
- 5.1 General
- 5.2 Protection against direct contact
- 5.2.1 Protection measures
- 5.2.2 Enclosure requirements
- 5.3 Connectors
- 5.4 Protection against indirect contact
- 5.4.1 IT system
- 5.4.2 General
- 5.5 Protection by potential equalization (equipotential bonding)
- 5.5.1 Potential equalization for components
- 5.5.2 Potential equalization for sockets
- 5.6 Isolation resistance requirements
- 5.6.1 Electric power train consisting of separate DC or AC buses
- 5.6.2 Electric power train consisting of combined DC- and AC-buses
- 5.6.3 Insulation monitoring
- 5.7 Parasitic coupling
- 5.7.1 Protective measures — Parasitic coupling
- 5.8 Test procedure for the protection against electric shock
- 6 Additional requirements for electrical sockets connecting to implements or attachments
- 6.1 Mated connection — General
- 6.2 Connect/Disconnect
- 6.3 Protection of electrical equipment
- 6.3.1 Short-circuits and overloads
- 6.3.2 Heat generating components
- 7 Conductors and cables used in higher voltage distribution — General requirements
- 7.1 Identification Colours
- 7.2 Identification of conductors for multicore cable
- 7.3 Creepage and clearance distances
- 7.4 Cable and wire insulation
- 7.5 Cross-sectional area
- 7.6 Multicore cables
- 7.7 Wiring that flexes
- 7.8 Flame retardancy
- 7.9 Protection of cables
- 7.9.1 Outer covering
- 7.9.2 General requirements — Protection
- 8 Wiring practices — General
- 8.1 Fastening and clamping
- 8.2 Routing
- 9 System requirements
- 9.1 Power on/power off procedure
- 9.1.1 Active state
- 9.1.2 Deactivated state
- 9.1.3 System state indication
- 9.2 Fault modes (indication)
- 10 Marking and symbols
- 11 Information for use
- 12 Service literature
- 12.1 General
- 12.2 Reduction of electrical hazards while servicing
- 12.2.1 Description of effects of electricity on the human body
- 12.2.2 Statements regarding risk reduction
- 12.3 Special procedures
- 12.3.1 Machine identification
- 12.3.2 First responder information
- 13 Technical documentation
- 13.1 General
- 13.2 Information to be provided
- 13.3 Overview diagrams and function diagrams
- 13.4 Circuit diagrams
- 13.5 Parts list
- Annex A (informative) List of hazards
- Bibliography [Go to Page]