eLibrary >
ISO 18413:2015 Hydraulic fluid power - Cleanliness of components - Inspection document and principles related to contaminant extraction and analysis, and data reporting >
ISO 18413:2015 Hydraulic fluid power - Cleanliness of components - Inspection document and principles related to contaminant extraction and analysis, and data reporting, 2015
- Foreword
- Introduction
- 1 Scope
- 2 Normative references
- 3 Terms and definitions
- 4 Inspection document principles
- 4.1 Content
- 4.2 Component cleanliness requirement
- 4.3 Inspection method
- 4.4 Effectivity
- 4.5 Conformance
- 4.6 Verification of conformance to specified component cleanliness requirements
- 4.7 Additional information
- 5 Guidelines for selecting contamination extraction and analysis procedures
- 5.1 Overview
- 5.2 Contaminant extraction
- 5.3 Contaminant analysis
- 6 Contaminant extraction principles
- 6.1 General
- 6.2 Overview
- 6.3 Extraction procedure setup and validation
- 6.3.1 Setup environment
- 6.3.2 Validation
- 6.4 Agitation
- 6.5 Pressure rinse
- 6.6 Ultrasonic vibration
- 6.7 Functional test method
- 7 Contaminant analysis principles
- 7.1 General
- 7.2 Overview
- 7.3 Gravimetric analysis
- 7.4 Determination of the largest particle size
- 7.5 Chemical composition
- 7.6 Particle size distribution
- 8 Data reporting principles
- 8.1 General
- 8.2 Overview
- 8.3 Contaminant mass
- 8.4 Particle size
- 8.5 Particle size distribution
- 8.6 Chemical composition
- 9 Criterion for acceptance
- 10 Identification statement (reference of this International Standard)
- Annex A (normative) Contaminant extraction principles — Agitation method
- Annex B (normative) Contaminant extraction principles — Pressure rinse method
- Annex C (normative) Contaminant extraction principles — Ultrasonic vibration method
- Annex D (normative) Contaminant extraction principles — Functional test method
- Annex E (normative) Contaminant analysis principles and data reporting principles
- Annex F (informative) Guidelines for the design of a functional test method test stand
- Annex G (informative) Determination of geometric characteristics of components
- Bibliography [Go to Page]