ASTM D2143-00
Historical Standard: ASTM D2143-00 Standard Test Method for Cyclic Pressure Strength of Reinforced, Thermosetting Plastic Pipe
SUPERSEDED (see Active link, below)
ASTM D2143
1. Scope
1.1 This test method covers the determination of the failure characteristics of reinforced plastic pipe when subjected to cyclic internal hydraulic pressure. It is limited to pipe in which the ratio of outside diameter to wall thickness is 10:1 or more.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1--There is no similar or equivalent ISO standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D618 Practice for Conditioning Plastics for Testing
D2992 Practice for Obtaining Hydrostatic or Pressure Design Basis for Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Fittings
D3567 Practice for Determining Dimensions of Fiberglass (Glass-Fiber-Reinforced Thermosetting Resin) Pipe and Fittings
Keywords
fiberglass pipe; hydrostatic design basis; pressure design basis; cyclic pressure strength; Cyclic pressure testing; Fiberglass pipe; Hydrostatic design basis (HDB); Pressure design basis (PDB); Pressure testing--plastic pipe/tube; Reinforced thermosetting-resin pipe (RTRP); Strength;
ICS Code
ICS Number Code 23.040.20 (Plastic pipes)
DOI: 10.1520/D2143-00
ASTM International is a member of CrossRef.
