ASTM D3943-00
Historical Standard: ASTM D3943-00 Standard Test Method for Total Molybdenum in Fresh Alumina-Base Catalysts
SUPERSEDED (see Active link, below)
ASTM D3943
1. Scope
1.1 This test method covers the determination of molybdenum in alumina-base catalysts and has been cooperatively tested at molybdenum concentrations from 8 to 18 weight%, expressed as MoO 3 . Any component of the catalyst other than molybdenum such as iron, tungsten, etc., which is capable of being oxidized by either ferric or ceric ions after being passed through a zinc-amalgam reductor column (Jones reductor) will interfere.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1193 Specification for Reagent Water
D7442 Practice for Sample Preparation of Fluid Catalytic Cracking Catalysts and Zeolites for Elemental Analysis by Inductively Coupled Plasma Atomic Emission Spectroscopy
E173 Practice for Conducting Interlaboratory Studies of Methods for Chemical Analysis of Metals
E507 Test Method for Determination of Aluminum in Iron Ores by Flame Atomic Absorption Spectrometry
Keywords
alumina-base catalysts (fresh); Jones Reduction; molybdenum; Alumina-base catalysts; Catalysts/catalyst carriers; Jones reduction; Molybdenum content ;
ICS Code
ICS Number Code 71.040.30 (Chemical reagents)
DOI: 10.1520/D3943-00
ASTM International is a member of CrossRef.
