|
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Description of BS EN ISO 4519:2016 2016This International Standard establishes sampling plans and procedures for inspection by attributes of electrodeposited metallic coatings. It may be applied to related finishes by agreement between the supplier and the purchaser. It is based on ISO 2859 (see also Addendum 1 to ISO 2859 ). The sampling plans in this International Standard are applicable, but not limited, to the inspection of end items, components, materials in process and finished products in storage. The plans are intended primarily to be used for a continuing series of lots, but they may also be used for the inspection of isolated lots. However, the assurance given for isolated lots is lower than that given for a continuing series of lots. This International Standard is not applicable to the sampling and testing of mechanical fasteners having electrodeposited metallic coatings or related finishes, in all the circumstances for which procedures for these components are specified in ISO 3269 . The sampling plans given in this International Standard are based on AQLs 1) of 1,5 and 4,0 %. Other AQLs may be used if specified in the product specification, in which case reference should be made to ISO 2859 and its Addendum 1. It is also possible to formulate sampling plans based on inspection by variables. Applicable but not limited to the inspection of end items, components, materials in process and finished products in storage. Annex on drawing of samples includes table of random numbers.
About BSIBSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses. |
GROUPS
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|